Industries ranging from analytical laboratory, HPLC, and bio tech to oil & gas exploration, and petrochemical should pay attention to cleaning and maintaining a stainless steel critical flow path. That's because a poorly cleaned surface will impact yield, product quality, lab results, and perhaps environmental compliance.
Cleaning stainless steel in some industries can be as simple as blowing the surface off with compressed air or a damp rag. In other industries, like environmental sampling, or stack sampling GC or HPLC chromatography, it's important to evaluate the solvent to be sure it does not leave trace contaminants on the surface which can lead to analyte adsorption or false positive results. Cleanliness is truly in the eye of the beholder.
In this blog post you will learn.
|
To take full advantage of a clean flow path, you have to clean the entire system. It's not a question of how do I clean a sample cylinder, or how do I clean stainless steel tubing or that fitting, valve or regulator. It's about cleaning the entire system for optimum performance. It does no good to clean tubing, valves and fittings in an analytical system only to discharge the contents of a dirty sample cylinder into the flow path.
So here are a few tips on maintaining and cleaning a stainless steel surface.
Have other questions about our CVD coatings?
Go to our Frequently Asked Questions Page
Do's and Don'ts of surface maintenance.
When to clean.
Clean more often than you think! Set a cleaning schedule and learn the signs of surface contamination. You don't need to see goop dripping out of a critical flow path to realize it needs to be cleaned. Signs you may need to clean the surface are:
How to clean your surface.
The key takeaway? Match the solvent to the contaminant:
Use the least aggressive, most effective high purity solvent. Why risk damaging or contaminating the surface if you don't need to. Always wear approved personal protective equipment and follow safety instructions as specified in MSDS, company, local, state and federal regulations when working with or around solvents.
Common effective solvents are:
Cleaning Method
Different industries have different approved cleaning methods. Research industry publications for best practices and develop your own written method to assure consistency. The Compressed Gas Association CGA G-4.1 is a valuable resource for establishing baseline cleaning criteria in a variety of industries. Here's the table of contents. Unfortunately you'll have to purchase the entire document, but it's worth it if you need to develop the best cleaning method for your application. Just click the image below to go to the CGA site.
Here are a few other sources for cleaning and sampling best practices: Just click the thumbnail images to go to the site.
Cleaning of stainless steel:
Natural gas stream sampling:
Air analysis sampling:
High purity tubing with cleaning information from Swagelok®.
What do semiconductor processing, stack probes, analytical instrumentation and refining have in common? They all have critical surfaces that must be maintained in order to keep their processes running smoothly. What areas, to what degree, and how surfaces are cleaned and maintained vary by industry. Our coatings assure a high purity high performance surface. Take a few minutes to watch our webinar to learn how to maintain coated surfaces. You'll be glad you did.
*image courtesy of Swagelok®